MOS'LIGHT V2.2
search
  • MOS'LIGHT V2.2
  • MOS'LIGHT V2.2
  • MOS'LIGHT V2.2
  • MOS'LIGHT V2.2

MOS'LIGHT V2.2

€25.00

This card allows you to control 16 TOYS of 1 amps max each with a MOLLUSK or WALTER.

It is designed to make the best use of 5 FLASH and 2 DTG Strob

Provided with JST PH connector for WALTER DRIVER.

Quantity

Here is the MOS'LIGHT of the Death that Kills which allows you to control 16 toys of 1 ampere max using your MOLLUSK or WALTER.

This card is designed to operate 5 12V RGB Flashes and 2 12V DTG Flashes, but it can just as easily take care of the 12V or 5V LEDs of your buttons, or manage small x-box type vibrators, everything is imaginable as long as you do not exceed the admissible powers.

With sockets for convenience, test LEDs on each output, and a fuse holder for proper protection (fuse supplied).

This card connects to a MOLLUSK or WALTER DRIVER.

Provided with JST PH connector for WALTER DRIVER.

THIS CARD SHOULD NEVER BE USED ALONE AND WITHOUT MOLLUSK or WALTER DRIVER AS THEY WILL DAMAGE YOUR INSTALLATION 

Each output receives an intensity of 1 amperes, the simultaneous consumption is limited to 16 amps. 

You can control toys from 0 to 20 Volts with the same card. 

The system consists of a card that is connected to the MOLLUSK or WALTER DRIVER using the sockets, or to WALTER DRIVER with JST PH the cables are not supplied, we also connect a + 12v from the toys power supply, as well as a GND from of feeding toys. The GND cable coming from the toys power supply must be of a section suitable for handling 16 amps! 

The outputs 1 to 15 have a common fuse holder with 3 outputs (1-2-3 / 4-5-6 / 7-8-9 / 10-11-12 / 13-14-15) with an included fuse of 3 amps.

Output 16 has a dedicated fuse holder with a 1 amp fuse included.

No more limit to the sensations on your pincab! 

Supplied with fuses

Documentation available in the Laboratory

MOSLIGHT_v2.2

You might also like

Comments (0)