• TeenCab
  • TeenCab
  • TeenCab
  • TeenCab



A Teensy 3.1/3.2/4.0 shield


Shield to properly connect a TEENSY 3.1, 3.2 or 4.0 in a pincab in order to manage the addressable leds, or for any other case.
A test button to test your leds and their color order.

Do not connect +5V on TEENCAB for a virtual pinball use !

Here is my solution to use your TEENSY in your Pincab. It has a test button that launches an RGBCMYW color sequence in order to properly configure your LEDs, so you will not have the flash each time the Pincab is started.

8 sockets to connect the 8 signal lines, one socket to connect the 5V power supply to the card.

The TEENSY is clipped onto the board using Dupont connectors.


WARNING !!! Never connect the LEDs if they are not supplied by their power supply.

The TEENSY must have the pins welded down !

Instructions available HERE



Firmware TEENSY 4.0

Firmware TEENSY 4.0 for TEENCAB

Download (61.27KB)

Firmware TEENSY 3.1 - 3.2

Firmware TEENSY 3.1 - 3.2 for TEENCAB

Download (34.59KB)

You might also like

Comments (0)