• New

Master of Mosfet

€60.00

Each card adds 16 PWM outputs with mosfet, test LED and fuse holder to one kl25z. The cards can be connected one after the other.

Out-of-Stock

Here is the new version of the 16 PWM mosfet extension!

Now with sockets for convenience, test LEDs on each output, all on a single 14 cm by 14 cm PCB.

This card connects to a kl25z. 

It uses 5 outputs (including a pwm) as well as the 5v and the GND of a kl25z. 

From there, you will have 16 additional pwm (modular) outputs, each with opto-electronic protection to properly separate the kl from the toy power supplies, an over-sized mosfet and a 5 * 20 fuse holder. Each output receives an intensity of 8 amperes, the simultaneous consumption is limited to 40 amperes. 

You can control toys from 0 to 48 Volts with the same card. 

You can connect several expansion cards one after the other without consuming new outputs on your kl25z. 

To put it simply, at the price of 5 outputs on the kl25z, you can add as many PWM outputs as you want! (nevertheless, I recommend not to exceed 192 outputs because the signal can deteriorate if it crosses too many cards ...) 

The system consists of a card which is connected to the kl using the sockets, the cables are not supplied, there is also a + 12v coming from the toys supply, as well as a GND coming of toy feeding. The GND cable coming from the toys power supply must be of section adapted to collect 40 amps! This GND terminal block is doubled to accept 2 cables of less section receiving 20 amps. 

This card has 16 fuse holders in 5 * 20 format and output sockets that you will connect to the positive terminal of the toy to be controlled. 

No more limit to the sensations on your pincab! 

Delivered without fuses

4 PCB feet in TPU offered!

Documentation available at the weekend

MASTERofMOSFETS
chat Comments (0)