Mosboard V3

€30.00
net of any taxes

A card with 8 mosfets, 8 test LEDs and 8 5 * 20 fuse holders

Quantity
Out-of-Stock


This card offers 8 Mosfet lines to connect your toys to the outputs available on your kl25z.

Each output can support 8 amps.

V3 !!!

- A LED to ensure that the card is powered.
- 8 blue LEDs to test if each output is active (perfect for configuration and troubleshooting).
- Signal input and power output sockets to facilitate installation and maintenance.

The card supports a maximum simultaneous current of 20 amps maximum. 

On the protection side, each line goes through a resistor to avoid consuming too much current and thus protect the KL25z from overheating, then an optocoupler to properly separate the voltage from the kl25z and the toy, and is equipped with a 5 * fuse holder 20 ( fuses not supplied ).

On one side, a socket system to connect the card to your kl25z (provide a 2.5mm precision screwdriver), on the other larger sockets to connect the card to your toys, and on the side an even more terminal block big to connect the card to the 12v and GND of your toy power supply.

Remember to connect the gnds of your power toys, and to properly size the GND power cable of the card (take awg14 or 1.5mm2 section) 

You can order toys of different voltages (48v max) with the same card because the order is made by the GND.

MosBoard_V3

Data sheet

Size
Weight

You might also like

chat Comments (0)