This card allows you to control 16 TOYS of 1 amps max each with a MOLLUSK.
It is designed to make the best use of 5 FLASH and 2 DTG Strob
Here is the MOS'LIGHT of the Death that Kills which allows you to control 16 toys of 1 ampere max using your MOLLUSK.
This card is designed to operate 5 12V RGB Flashes and 2 12V DTG Flashes, but it can just as easily take care of the 12V or 5V LEDs of your buttons, or manage small x-box type vibrators, everything is imaginable as long as you do not exceed the admissible powers.
With sockets for convenience, test LEDs on each output, and a fuse holder for proper protection (fuse supplied).
This card connects to a MOLLUSK.
THIS CARD SHOULD NEVER BE USED ALONE AND WITHOUT MOLLUSK AS THEY WILL DAMAGE YOUR INSTALLATION
Each output receives an intensity of 1 amperes, the simultaneous consumption is limited to 16 amps.
You can control toys from 0 to 20 Volts with the same card.
The system consists of a card that is connected to the MOLLUSK using the sockets, the cables are not supplied, we also connect a + 12v from the toys power supply, as well as a GND from of feeding toys. The GND cable coming from the toys power supply must be of a section suitable for handling 16 amps!
The outputs 1 to 15 have a common fuse holder with 3 outputs (1-2-3 / 4-5-6 / 7-8-9 / 10-11-12 / 13-14-15) with an included fuse of 3 amps.
Output 16 has a dedicated fuse holder with a 1 amp fuse included.
No more limit to the sensations on your pincab!
Supplied with fuses
You might also like
4 other products in the same category:
MOS8 3D Holder
MOLLUSK & MOS4 3D Holder