This card allows you to control 4 TOYS of 8 amps max each with a MOLLUSK
Here is the MOS4 which allows you to control 4 toys of 8 amps max using your MOLLUSK
With sockets for convenience, test LEDs on each output, and a fuse holder for proper protection (fuse not supplied).
This card connects to a MOLLUSK.
THIS CARD SHOULD NEVER BE USED ALONE AND WITHOUT MOLLUSK AS THEY WILL DAMAGE YOUR INSTALLATION
Each output receives an intensity of 8 amps, the simultaneous consumption is limited to 20 amps.
You can control toys from 0 to 48 Volts with the same card.
The system consists of a card that is connected to the MOLLUSK using the sockets, the cables are not supplied, we also connect a + 12v from the toys power supply, as well as a GND from of feeding toys. The GND cable coming from the toys power supply must be of a section suitable for handling 20 amps!
This card has 4 fuse holders in 5 * 20 format and output sockets that you will connect to the negative terminal of the toy to be ordered.
No more limit to the sensations on your pincab!
Supplied without fuses
You might also like
4 other products in the same category:
MOS8 3D Holder